15ft PL259 to Mini UHF LMR240 Times Microwave Jumper UHF VHF Coax Cable 15ft

N-male-update
Motorola Mini UHF / PL-259 Connectors on LMR-240 RF Antenna Coaxial Cable | PL-259 Male to Mini-UHF Male LMR-240 Antenna Coaxial Cable Made – Assembled –
Produced and Shipped from the USA
US Made
Coaxial cable assembly!
Major
brands who source offshore maintain their own quality engineers to test
and monitor cable produced for them. Cable failing quality inspections
is sold off to users on eBay falsely labeled as Times or another brand
name. Times Microwave is not the only quality coax cable producer still
operating in the US we offer several other brands such as
Commscope/Andrew and Coleman as well. But by all means, do your
Homework!
Is
the cable you are looking at Described as
“Compare to” “Equivalent
to””Replacement for” 
“Same as” or even
“Like”
LMR-400 ? 
This is common with poor quality cable made in Mainland
China or some other lesser known locations.
eBay is allowing
sellers to List cable in the titles and description as LMR-400 when it
is NOT.  Don’t buy without asking if a product is Genuine
Times Microwave.
Real
LMR400 Coaxial Cables
Cables
Produced, Assembled, and Fabricated In The USA with US Made Coax
MORE
Ultra Low Loss
LMR-400 N male to N male Cables
Linksys, CISCO, others N male to RP-TNC Male Antenna
Cables for WiFi
New RP-TNC Male to Female Cables to Extend Wireless
Internet Antennas
N Male to RP-SMA Coaxial Antenna Cables at the store
page here
New RP-SMA Male to Female Cables to Extend Wireless
Internet Antennas
PL-259 UHF CB LMR-400 Coax Cables
PL-259  to N MALE UHF CB LMR-400 Coax Cables
Other Mini-UHF Cables
Need another length?
Just
Ask!
Listings
for SMA/BNC/N/etc HERE
Tech Specs
Connector(s)
Product
Description
Mini-UHF
LMR240
Ultra Low Loss – antenna cable
Connector(s)
(Other Side)
Length
PL-259
15 ft
Technology
Type
Coaxial
Cable 50 Ohms
Antenna
cable – Connects Access Points, Routers and Radio transmitters to
Antenna
Network
Cable Type
Antenna
cable
Waterproof
connectors
We have many listings for cable
sets with different connector configurations
.  We
will also
professionally replace
connections as needed with high quality SMA, BNC, RP-SMA, N, RP-TNC or
TNC ends in
male or female for $2.99 each to customize cable for your needs.
Cable
that fails to
meet name brand manufacturers standards is not
destroyed but is sold as generic, off brand or “house brand” cable all
over eBay.
Too
much
attenuation or signal loss?
send
it back
.  VSWR too high?
Send
it back
.
   Please see
the fine print!
The Fine Print
:
If you cut it up you keep it.
Cable
should be in “like new” condition, teeth marks/burns/slices etc. are
not acceptable.  Please don’t run it up a tower and scrape/fray
it then change your mind.  Run all tests while still coiled.
If we have installed custom connectors
we will not refund the price of the new connector we installed for you.
If
you
have installed custom connectors we will not refund what you paid for
them.
LMR-400
Coaxial Cable Info
Cable for most all CB, Ham and WiFi installs needs to be
50
ohms;
cheaper
cable not meeting this standard or cheap mismatched connectors
significantly increases signal loss.  It is more expensive to
manufacture
50 ohm cable than 75 ohm, so many cheaper producers tend to substitute
without telling or use cable with variable dielectric thickness and
copper alloys less than 95% pure for poor conductivity.
 Certain
Chinese plants make cable for a large number of resellers and as copper
prices go up, the quality of the alloy used tends to go down to
maintain a price point.
U.S. Made
LMR-400
Coaxial
cable should not be confused with the imitations sold
calling
themselves
LMR400
in most eBay listings.  There ARE other
quality
coax producers out there other than Times Microwave.  We sell
a
couple ourselves, but please – if you don’t buy here do your homework.
Coaxial cable
design choices affect physical size, frequency
performance, attenuation, power handling capabilities, flexibility,
strength and cost.  Skinny cable has less metal to conduct
your signal and causes more loss.
Cable MUST be precision manufactured with precise standard
spacing between conductors to
avoid significant signal loss.
Quality control
is Key!
============================================================
Signal
losses are frequency dependent
, the losses becoming
higher
as the
frequency increases. It is not unusual to experience 5 times as much
signal loss at 6 GHz than at WiFi’s 2.4 GHz.  
 Installing a 15Db gain
antenna and running cheap antenna cable can result in cable loss of
twice your antenna gain.  Don’t bother buying a good antenna
if you are
running cheap cable. Losses can be
reduced by
increasing
the diameter of the cable.
A cable
with twice the
diameter will have half the signal effect resistance loss.
Assuming cable quality is equal, the larger cable would
halve
the
dB/meter loss. In
designing a system, consider not only the loss in the cable,
but also the loss in the connectors. Cheap connectors give you as much
loss as cheap cable. On a final note, poorly made LMR600 “type” cable
can have a greater signal loss than good LMR400…  (See the
cable
chart below.  Run the largest, best quality cable you can
afford.)
This
is Top Quality LMR400 50 Ohm Cable
.  All common
Radio Frequency (RF) devices CB, Ham, WiFi, Packet Radio, etc. are to
be used with 50 Ohm cables and connectors.
75 Ohm
cables and connectors are designed for low frequency signals
like Video or Cable TV and are unsuitable for
most
all RF
installations
.
 Each type of
coaxial cable has a
characteristic impedance
(
resistance
)
depending on its dimensions and construction, which is the ratio of the
voltage to the current in the cable. In order to prevent reflections at
the destination end of the cable from causing standing waves. The
equipment “appears” electrically
similar to a continuation of the cable, preventing reflections that
cause signal degradation.
In
high quality cable the dimensions and spacing of the conductors are
uniform.
Any abrupt
change in the spacing of the two conductors along the cable tends to
reflect radio frequency power back toward the source, causing a
condition called
standing
waves
.
This acts as a bottleneck, reducing the amount and quality of the
transmitted power. To hold the shield at a uniform distance from the
central conductor, the space between the two is filled with a plastic
dielectric
designed to maintain the
proper spacing between conductor and shielding to assure maximum signal
transmission and lowest loss. 
Manufacturers specify a minimum bend radius, to prevent kinks that
would cause reflections.
You
should allow one inch of cable to make a 90 degree turn in your
runs without causing signal loss.
The connectors used with
the coax must also hold the correct
spacing through the body of the connector to avoid signal
loss. The transmission of energy in the line occurs totally
through
the
dielectric
inside the cable between the conductors. This cable can be
bent and moderately twisted without negative effects, and can be
strapped to conductive supports without inducing signal interference.
LMR-400 cable
is
designed for outdoor applications, can be direct buried, and the outer
jacket resists
ultraviolet
light
and
oxidation
. There is no environmental
restriction on use for indoor installations.
International
Customers
We
will Gladly ship to most Countries pursuant  to the following
rules:
EBay
Customs Notice for
International Buyers
:
(In compliance to EBay
International
Sales Instructions)
We have never
had a package taxed by Customs but there is
always a possibility.
International
Buyers
– Please Note:
Import
duties, taxes and charges are
not
included
in the item price or
shipping charges. These charges are the buyer’s responsibility.
Please
check with your country’s customs
office to determine what these additional costs will be prior to
bidding/buying.
These
charges are normally collected by the delivering freight (shipping)
company or when you pick the item up – do not confuse them for
additional shipping charges.
We
do not mark merchandise values below value or mark items as “gifts” –
US and International government regulations prohibit such behavior.
ALL
international shipping is done via USPS Air Mail. You can check the
rates for your location at USPS.Com and just add $2 to the direct cost
to pay for our packaging and transport. I can ship
other
ways but the cost is
much
more expensive.  Shipping to Canada
is double
for signature items with tracking numbers and delivery to Europe and
Australia is
more than triple the USPS Air Mail cost.  In most cases it is
not
cost
effective to buy my items and pay three times the price to ship
them…  For more expensive items over $50 I will offer the
option of
tracked shipping but in most cases you will be better off buying
locally
On Nov-19-10 at 16:30:26 PST, seller added the following information:
On Oct-27-11 at 19:47:21 PDT, seller added the following information:
Froo www.froo.com | Froo Cross Sell, Free Cross Sell, Cross promote, eBay Marketing, eBay listing Apps, eBay Apps, eBay Application
On Feb-27-12 at 17:26:15 PST, seller added the following information:
Every buyer gets a MyStoreRewards invitation for cash back